flash_common_all.h

Go to the documentation of this file.

/** @addtogroup flash_defines
 *
 */
/*
 * This file is part of the libopencm3 project.
 *
 * This library is free software: you can redistribute it and/or modify
 * it under the terms of the GNU Lesser General Public License as published by
 * the Free Software Foundation, either version 3 of the License, or
 * (at your option) any later version.
 *
 * This library is distributed in the hope that it will be useful,
 * but WITHOUT ANY WARRANTY; without even the implied warranty of
 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
 * GNU Lesser General Public License for more details.
 *
 * You should have received a copy of the GNU Lesser General Public License
 * along with this library.  If not, see <http://www.gnu.org/licenses/>.
 */
 
#pragma once
 
#include <libopencm3/cm3/common.h>
 
BEGIN_DECLS
 
/**
 * This buffer is used for instruction fetches and may or may not be
 * enabled by default, depending on platform. (F1: yes, most others: no)
 * 
 * Note carefully the clock restrictions under which the prefetch buffer may be
 * enabled or disabled. Changes are normally made while the clock is running in
 * the power-on low frequency mode before being set to a higher speed mode.
 *
 * Note carefully that prefetch may also results in increased consumption
 * and can only improve performance on "mostly linear" workloads where there
 * is at least one flash wait state.
 *
 * See the reference manual for your particular target for more details.
 */
void flash_prefetch_enable(void);
 
/**
 * Note carefully the clock restrictions under which the prefetch buffer may be
 * set to disabled. See the reference manual for details.
 */
void flash_prefetch_disable(void);
 
 
/** Set the Number of Wait States.
 
Used to match the system clock to the FLASH memory access time. See the
programming manual for more information on clock speed ranges. The latency must
be changed to the appropriate value <b>before</b> any increase in clock
speed, or <b>after</b> any decrease in clock speed.
 
@param[in] ws values from @ref flash_latency.
*/
void flash_set_ws(uint32_t ws);
 
/** Lock the Flash Program and Erase Controller
 * Used to prevent spurious writes to FLASH.
 */
void flash_lock(void);
 
/** Unlock the Flash Program and Erase Controller
 * This enables write access to the Flash memory. It is locked by default on
 * reset.
 */
void flash_unlock(void);
 
/** Unlock the Option Byte Access.
 * This enables write access to the option bytes. It is locked by default on
 * reset.
 */
void flash_unlock_option_bytes(void);
 
END_DECLS